Is there a way to tell matlab that set(gcf,'Visible','off') actually means don't show figures?

21 次查看（过去 30 天）
Leo Simon
Leo Simon 2020-10-23
编辑： Bruno Luong 2020-10-23
Unfortunately my code is sufficiently complex that I can't provide an MWE, but when I turn gcf Visibility off, using `set(gcf,'Visible','off') ` and then create a patch object, the patch object flashes on for an instant then turns off again. This is a problem, since I'm creating a large number of patch objects. Is there some command that actually turns Visibility off rather than flashing the patch on and off?
Thanks!
  4 个评论
显示 2更早的评论
Leo Simon
Leo Simon 2020-10-23
Thanks to both for quick responses. Ameer, I tried `opengl software` and it didn't make any difference. Walter, I'm afraid I don't understand your answer. What do you mean by "recording the figure handle" and when should I provide it? Apropos of "as early as possible," my code begins with the command `set(groot,'DefaultFigureVisible','off') `which I thought was supposed to turn visbility off for all figures, but it doesn't.
I looked at the two entries under the always-parent tag, but couldn't see the connection to my problem, probably I'm being dumb.
Bruno Luong
Bruno Luong 2020-10-23
编辑：Bruno Luong 2020-10-23
Can't reproduce what you post, I don't see any flash with this code
clear
close all
h=figure;
fprintf('Type Ctrl C when you have enough\n')
set(h,'Visible','off')
ax=axes(h);
while true
surf(ax,peaks);
pause(0.1);
end
What is your minimal working example code? It leads nowhere if you can't provide MWE.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Graphics Object Programming 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by