How can i get eigen values from simulink model

40 次查看（过去 30 天）
krishan sharma
krishan sharma 2013-2-5
评论： SinanB 2017-7-11
i made my simulink model and run it in steady state and find initial operating state.i want to find eigen values around this operating point.further if i create small perturbation in system,how can i get eigen value after perturbation. please suggest me

请先登录，再回答此问题。

回答（2 个）

Ryan G
Ryan G 2013-2-5
You can use the linear analysis tool to first find the operating point (using operating point snapshot). Then you can linearize the model around this operating point. From here you can find the A matrix from the result and use the EIG function.
  1 个评论
SinanB
SinanB 2017-7-11
I tried this but Eig(linsys1.A) don't give the expected poles (indicated in the power_PSS example such as 0.64Hz, 1.12Hz and 1.16 Hz). Please note that for the related modes, damping is so small that natural frequencies are approximately the same as the complex part of the poles.
Note that the eigenvalues can also be obtained by damp(linsys1).

请先登录，再进行评论。

SinanB
SinanB 2017-7-7
I tried this but Eig(linsys1.A) don't give the expected poles (indicated in the power_PSS example such as 0.64Hz, 1.12Hz and 1.16 Hz). Please note that for the related modes, damping is so small that natural frequencies are approximately the same as the complex part of the poles.
Note that the eigenvalues can also be obtained by damp(linsys1).

类别

在 Help Center 和 File Exchange 中查找有关 Trimming and Linearization 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by