Hello, I was trying to generate code for TI DSP form the simulink model. It is a 3 phase pwm rectifier. But the code I generated doesn't look like that I can use for the DSP. My question is : # Do I need to make changes to my model in order to generate code? # Can I generate the required code for the DSP by only using Simulink or do I need to connect it to the real DSP board? # There is hardware implemetation in the parameter configuration dialogue and also a system preference block. Both of them can be used to chose a hardware. Which one should I use? Thank you so much.

generating code from embedded coder

Chenyang Zhang

2013 2 15

0 个回答

更新时间：2021 8 20

1 次查看（30 天）

Follow Question

信息

此问题已关闭。请重新打开它进行编辑或回答。

显示更早的评论

0 个投票

Hello, I was trying to generate code for TI DSP form the simulink model. It is a 3 phase pwm rectifier. But the code I generated doesn't look like that I can use for the DSP. My question is :

Do I need to make changes to my model in order to generate code?
Can I generate the required code for the DSP by only using Simulink or do I need to connect it to the real DSP board?
There is hardware implemetation in the parameter configuration dialogue and also a system preference block. Both of them can be used to chose a hardware. Which one should I use?

Thank you so much.