Subtracting angles in a unit circle

Question

Andrew 2013-2-15

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/63657-subtracting-angles-in-a-unit-circle

I need to adjust my angles in a unit circle by 32 degrees in a dataset, but need to keep my range from -360 to 360 (2 rotations or 720 degrees). So instead of 360 to -360 it will now be 32 to 328, but still have two full rotations or 720 degrees.

Does this make sense? And if so, any clever tricks?

3 个评论
显示 1更早的评论隐藏 1更早的评论

Andrew 2013-2-15

A quick explanation is that Top Dead Center (TDC) of a Crank on an engine is -360 or 360. so every measurement starts at -360 degrees and makes two rotations, -360 to 0 and 0 to 360. my problem is that TDC was set wrong to +16 degrees at the start of my test. My TDC is now starts at -344. I need to adjust my entire data set so that my forces align with the correct angles. I hope that makes better sense.

Andrew 2013-2-15

so 361 should be 1 degrees and 362 should be 2 degrees and so on. There is a LOT of data. I just need a simple way to convert any thing greater than 360 back to 1,2,3, and so on degrees.

I was just looking for a simple way to do it, and figured there has to be a way to stay on a unit circle.

请先登录，再进行评论。

请先登录，再回答此问题。