Csv read and figure generation
显示 更早的评论
Hello everyone,
I am new on Matlab and need one help. At attached my csv data which i want to read on matlab and want to create a figure ( Column B on X axis and Column C on Y axis). It is basically ratingtime vs Velocity.
Could you please help me ?
Thank you very much in advance
2 个评论
Walter Roberson
2020-11-8
What is the expected interpretation of
09276215;0;;;;;;;;
3943927;-3
Your column 1 is all 0 until row 1264, and column 2 has leading digits that are increasing up to that point. Then at row 1264 column 1 becomes 1 and the leading digit of column 2 goes back to 0. It looks to me as if column 1 and column 2 together form a number.
Question: has this been produced on a system that uses comma as a decimal separator, and semicolon as the field separator?
Mohammed Cha
2020-11-8
采纳的回答
Walter Roberson
2020-11-8
S = fileread('myData.csv');
S(S==',') = '.';
data = cell2mat( textscan(S, repmat('%f', 1, 11), 'Delimiter', ';', 'headerlines', 1));
plot(data(:,2), data(:,3));
1 个评论
Mohammed Cha
2020-11-8
Hello Walter, I have a small question on your code. Yes i need to plot column 1 and 3 as its time and velocity. I had did mistake in csv. I just edited the code and tried to make figure as attached. Could you please help me to remove noise from it? marking in figure stets which i need to plot other things (such as second wave after first wave) want to remove. My samling rate is 10000Hz.
S = fileread('RawData.csv');
S(S==',') = '.';
data = cell2mat( textscan(S, repmat('%f', 1, 11), 'Delimiter', ';', 'headerlines', 1));
time=data(:,1)
t=time(3:end)
Measured_signal_=data(:,3)
Measured_signal=Measured_signal_(3:end)
plot(t,Measured_signal)
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Data Type Conversion 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
