How to "Monitor and Tune" Simulink Model from MATLAB

25 次查看（过去 30 天）
Blake Stevenson
Blake Stevenson 2020-11-15
评论： Blake Stevenson 2020-11-28
I have a Simulink model that controls a DC motor's position. The angular position for the motor to rotate to comes from a constant block, which I write to in a Matlab script using set_param. I've seen how set_param('modelName', 'SimulationCommand', 'start') can be used to start a simulation within Simulink, but is there a similar command to run the model [on hardware] in the "Monitor and Tune" mode?
I want to run the model on the hardware connected to my PC (Arduino Mega), but at certain points in the script, I need the motor to move to a different position. Thus, I still need to be able to write to the model using set_param, so I cannot just build and deploy the model to hardware.
Any advice is appreciated.

请先登录，再回答此问题。

采纳的回答

Chaitanya Mallela
Chaitanya Mallela 2020-11-26
You can try out this command for Monitor and Tune mode
set_param(gcs, 'SimulationMode', 'external')

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Run on Target Hardware 的更多信息

标签

产品


版本

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by