UAV Toolbox Support Package for PX4 Autopilots Error

2 次查看（过去 30 天）
Ahmed Ashraf
Ahmed Ashraf 2020-11-16
编辑： Remo Pillat 2024-7-19
Whenever i try an Example simulation on my Pixhawk 1 i get this error. Any fixes?
Error occurred while executing External Mode MEX-file 'ext_comm':
Unexpected response from target. Expected EXT_CONNECT_RESPONSE.
Component:Simulink | Category:Block diagram error
Unable to connect to the 'PX4 Pixhawk 1' target for 'px4demo_Read_Parameter'
  2 个评论
Ankur Bose
Ankur Bose 2020-11-17
Hello,
Can you confirm that you have run the PX4 Hardware setup screens and inserted an SD card to Pixhawk 1 with custom startup script as described here?
Also, please check that the Enable MAVLink checkbox in the Configuration parameters are not selected.
Ankur
Ahmed Ashraf
Ahmed Ashraf 2020-11-17
yes i did all of the above, yet i still get the same error code

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Remo Pillat
Remo Pillat 2024-7-19
编辑：Remo Pillat 2024-7-19
It has been a few years since this question was raised. If you still face errors or problems, please reach out to MathWorks Support, so we can take a closer look at your software and hardware configuration.

类别

在 Help Center 和 File Exchange 中查找有关 PX4 Autopilots 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by