New questions and valuation of final results
1 次查看(过去 30 天)
显示 更早的评论
Good again, I followed by testing and the truth I'm a little confused. By plotting the predicted values in closeloop confuses me a bit and I can not understand the results, When I get low is when R2tst generalizes better because if I get high values both in train, validation and test accuracy is great I just suspect overfitting occurs because it is very similar and it is displaced with respect to the graph of original targets. Practically the resusltados I posted in the previous post. If anyone can explain this I would really appreciate it as I think is the last step and the one that deserves special attention in order to interpret the data correctly. Thank you very much.
0 个评论
采纳的回答
Greg Heath
2013-3-1
Before you close the loop, use tr to closely examine the trn, val, and tst results. The order of importance is tst, val , trna (adjusted for reduced DOF) and trn.
If you are satisfied, close the loop and run the same data though to compare results.
If you are satisfied with those results, then consider new data.
Signs of overfitting:
Ntrneq >> Ndof = Ntrneq-Nw
R2trna << R2trn
R2tst, R2val << R2trn
Hope this helps.
Thank you for formally accepting my answer.
Greg
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Modeling and Prediction with NARX and Time-Delay Networks 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!