How to continuously write data into ThingSpeak when using Vehicle Network ToolBox?

2 次查看（过去 30 天）

Wen Yin Tay 2020-12-2

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/674293-how-to-continuously-write-data-into-thingspeak-when-using-vehicle-network-toolbox

评论： Wen Yin Tay 2020-12-10

Hi,

I am using Vehicle Network Toolbox to retrieve vehicle speed from my vehicle, then I wish to send the vehicle speed continuously to ThingSpeak for data analysis.

May I know how can I do that?

Thank you.

4 个评论
显示 2更早的评论隐藏 2更早的评论

Christopher Stapels 2020-12-7

Is the system that is monitoring the vehicle speed in the car? If that system is running MATLAB and is connected to the internet, you might be able to use sendmail to send an email without ThingSpeak.

You could also use the ThingSpeaks alert service. There is a code template in MATLAB analysis that shows you how to send a mail based on a channel threshold.

You can calculate the average velocity locally and send it at regular intervals to ThingSpeak.

Wen Yin Tay 2020-12-10

Hi, thanks for replying :)

Yes! I am developing the system that is monitoring the vehicle speed. I am using NI-XNET 8052 to get the signal from the vehicle with the help of Vehicle Network Toolbox. So far, I have identified the Standard CAN ID for the vehicle speed, as we can see from the picture below, the red box highlighted the vehicle speed. For now, I am not sure how to read the bit value only. If you happen to know the way, can you share it with me? Thanks.