How do I get MATLAB to output a digital marker via the parallel port to Biopac's Acqknowledge software?
6 次查看(过去 30 天)
显示 更早的评论
I'm basically using MATLAB in place of E-Prime/Superlab/DirectRT etc. In order to mark Acqknowledge (Biopac) with a digital marker (and trigger acquisition), I require the STP100C - This module would accept a digital marker via the parallel port. Therefore, I need to program MATLAB to output a digital marker via the parallel port of the computer, I'm sure there must be some command for that.
I am trying to collect Event Related Potentials and I have 2 targets/stimuli (T1 & T2). These are letters that are part of a rapid serial visual presentation. After each string is presented, the participant has to reply yes/ no to whether T1 or T2 was presented. As far as physiology is concerned I am measuring the onset of the P300.
0 个评论
采纳的回答
PT
2013-3-26
编辑:PT
2013-3-26
Take a look at "digitalio" in the Data Acquisition Toolbox. Here's a short example code:
% Initialize 2 lines (2nd line reserved for future use)
ppobjects.dio = digitalio('parallel', 'LPT1');
ppobjects.lines = addline(ppobjects.dio,1:2,'out');
% Set line 1 to high
linenum = 1;
value = 1;
putvalue(ppobjects.lines(linenum),value);
% Set line 1 to low
linenum = 1;
value = 0;
putvalue(ppobjects.lines(linenum),value);
4 个评论
PT
2013-4-1
In that case, wire line 1 and gnd of parallel port to the signal and return on your device's digital input. From Wikipedia, it should be pin 2 or 3 for + and any of the gnd pins for -.
更多回答(1 个)
steamrice
2020-1-28
I am haveing a similar software and hardware design problem using biopac and stp100C. Could someone help?
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Data Acquisition Toolbox Supported Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!