not getting how to plot output sensitivity using bode diagram in simulink

2013 4 1
1 个回答
回答已采纳
28 次查看（30 天）

0 个投票

Hello i want to plot output sensitivity in simulink, how to plot it. right now i am using linearization points as we can seen in figure at output side and plat output side. and using bode block in simulink , this procedure right to plot sensitivity ?

请先登录，再回答此问题。

 采纳的回答

0 个投票

Yes, that should give you 1/(1+P*C), where C is the transfer function corresponding to your inner loop.

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Simulink Design Optimization 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by