pid controller block parameter

2013 4 4
1 个回答
回答已采纳
更新时间：2018 9 19
10 次查看（30 天）

0 个投票

hello, my name is Nitin. I am undergraduate student. I am trying to design ac(100) to dc(200) converter using 4 IGBT connected in bridge. That boost converter is working but when I am taking feedback from output and compared with reference Voltage and given to PID(proportional and Integral) to get the output voltage regulated to 200. It is taking time to regulate as well as it is not even regulating to 200V. I want to know how to adjust the value of PID. I have read all the study material still not able to solve the problem. specification are.. vin=100,50hz vout=200 capacitor value Cout =10000uf inductor value Lin =69uH resistor Rout =10ohm. Vref= 0.5 PWM frequency =4khz right now PID values are P= 0.65,I=2,D=.001,N=100.. please help...............I don't know how to add .mdl file over here that's why I have given all the specification.

3 个评论
显示 1更早的评论 隐藏 1更早的评论

Ryan G
Ryan G 2013-4-4
Are you able to use the 'tune' button in the PID block? Does your system linearize well? This can significantly simplify the process.
nitin
nitin 2013-4-6
thanks for reply.... sir, whenever I am trying to tune the model it is giving me error and that is
The plant model in the PID loop linearizes to zero, and therefore cannot be used in PID controller design. This problem occurs when one or more blocks in the PID loop have zero gain or the feedback loop is not physically closed. Click "Continue" to launch the PID Tuner and obtain a new plant model in the "Obtain plant model" dialog. Click "Cancel" to return to the PID Controller block dialog. For more information, see the Simulink Control Design documentation.
and when I am clicking on continue button it is adjusting the value of P=0 and I = -1. after auto tuning also the output is not coming. should I sent u .mdl file so that it will be easy for you to help me. sorry but I don't know how to add .mdl file over here.
thanks once again....... I am very much new to Simulink ... please help.... nitin
Ishu J
Ishu J 2018-9-19
hello sir, I have the same doubt while tuning PID controller. Also in my simulink i have two controllers so how to tune those?

请先登录，再进行评论。

请先登录，再回答此问题。

 采纳的回答

Arkadiy Turevskiy
编辑：Arkadiy Turevskiy 2013-4-8

0 个投票

Hello Nitin,
PID Tuner works by linearizing the model. It then uses the linearized model to come up with the gains. It is very common to run into zero linearization issue when working with electrical systems like you are doing. Often this happens when pwm is used.
Often times this problems can be solved by linearizing the model at a different operating point than the default one (by default the model is linearized at simulation time 0). This and other suggestions are explained in detail in the documentation here.
You may also find this video and this webinar useful.
HTH.
Arkadiy

更多回答（0 个）

类别

在 帮助中心 和 File Exchange 中查找有关 Tuning, Analysis, and Validation 的更多信息

产品

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by