Combine signals in Simulink
2 次查看(过去 30 天)
显示 更早的评论
How can I combine a signal from conditional subsystem with a normal signal? I want to combine a power signal from a source with two signals from conditional subsystem that are connected with this input signal. When I use Merge block it says that it cannot be connected, because Merge block can use only signals from conditional subsystems. Is there another way to combine these two signals into one without using Merge block.
2 个评论
回答(1 个)
Rhea Chandy
2021-1-4
Hello Jurica,
As you say in your post, only conditionally executed subsystems can be used to drive Merge blocks. The guidelines and limitations of merge blocks are in the following documentation, and you an refer to this for further information on how to use them effectively: Merge Blocks
You may use an array of buses as an input signal to a Merge block,(with certain limitations) to combine inputs into a single output. Further, you can also try using a Mux block, which combines inputs with the same data type and complexity into a vector output, although this doesn't give the same output as the Merge block. You can refer to this information on combining signals: Composite Signals.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Sources 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!