"Parametric Audio Equalizer for STM32 Discovery Boards" errors by pressing the "Monitor & turn" button.

8 次查看（过去 30 天）
liangmaokun liangmaokun
评论： liangmaokun liangmaokun 2021-1-18
The errors returned are shown below:
External Mode Open Protocol Connect command failed
Caused by:
DWARF Parser internal error: Parser::describeSymbol xcpDummyDoubleVariable is not a global variable
Component:Simulink | Category:Block diagram error
Unable to connect to the 'STM32F746G-Discovery' target for 'stm32f746gdiscovery_audio_equalizer'.
Component:Simulink | Category:Model error
This project is loaded from "Embedded Coder Support Package for STMicroelectronics Discovery Boards".
If pressing "run" or "Build,Deploy & Start",there is no error returned.
If other modules are commented out and only input and output are left, as shown in the figure, this error message will still be reported. This problem will not appear on the stm32f4 disco development board. Note that stm32f4 uses an additional ttl-233.

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 STMicroelectronics Discovery Boards 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by