How to connect the two signals in one signal in MATLAB Simulink? I mean first signal finishes second signal starts.

32 次查看（过去 30 天）

amenah Muwafaq 2020-12-26

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/703052-how-to-connect-the-two-signals-in-one-signal-in-matlab-simulink-i-mean-first-signal-finishes-secon

评论： Walter Roberson 2020-12-29

I want to combine the three signals in the circle in red with the signals in the circle in yellow, so that the signs in the red color end in the display and the signs in the yellow circle start in the display. how I do that? A

ny answer is appreciated...

2 个评论
显示无隐藏无

Les Beckham 2020-12-27

Is the transition determined by a specific point in simulation time or a specific value of one of the two signals?

amenah Muwafaq 2020-12-28

编辑：amenah Muwafaq 2020-12-28

Hi, Les Beckham

the transition is determined by a specific point in simulation time.

what I doing? please...

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Jim Riggs 2020-12-27

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/703052-how-to-connect-the-two-signals-in-one-signal-in-matlab-simulink-i-mean-first-signal-finishes-secon#answer_584897

You description of the problem is confusing to me, bu the statement in the title

"first signal finishes second signal starts"

suggests to me that you might want a "merge" block. This is exactly what the merge block was designed for.

This block accepts two inputs and outputs the active input. There are two requirements;

Both input signals must be the same type.

Only one signal can be active.

If this is not right, please clarrify what you are looiking for.

6 个评论
显示 4更早的评论隐藏 4更早的评论

Walter Roberson 2020-12-29

Signals do not "end" in Simulink unless they are in a subsystem that gets disabled.

Are you wanting to produce a series of frames from your rgb source, and then after the last of the series gets displayed, switch the rgb off and switch the YCrCb source on?

Are you wanting to interleave frames, one from the rgb source then one from the YCrCb source?

Are you wanting to display a single frame that has the rgb source on top and the YCrCb source below it? Or left / right instead of top/bottom?

amenah Muwafaq 2020-12-29

Walter Roberson

My design is as follows, read a video, use (Frame to Stream) block, to convert the frame into a stream, divide the stream into two halves, then do a specific treatment on each half of the stream. At the end, I want to link the two halves of the stream like the original stream and use the (Stream to Frame) block to convert the stream to a frame and then Show the video

My problem is how to link two streams into one stream the same as the original stream.