Hi Van,
To control a Thorlabs LCC25 box in MATLAB using the "serialport" function:
Determine the correct COM port and communication settings (baud rate, data bits, stop bits, parity) from the LCC25 manual.
Establish Connection
port = "COM3"; % Replace with your COM port
baudrate = 115200; % Replace with the correct baud rate
serialObj = serialport(port, baudrate);
% Configure settings as needed
Send Commands and Read Responses
command = "your_command_here"; % Replace with LCC25 command
write(serialObj, command, "string");
response = readline(serialObj);
Close Connection
delete(serialObj);
clear serialObj;
Ensure you replace placeholders with actual commands and settings for the LCC25. Always refer to the device manual for accurate command syntax and communication settings.
