How to give my PI controller initial value?

35 次查看（过去 30 天）
Adeel Ashraf
Adeel Ashraf 2021-1-5
评论： Jon 2023-9-6
As my system initialize at 1800 RPM. I want to give inital value to my PI controller to remove the swing curve as you can see in my scope result. So that I can reduce the simulation time.
But I don't know how to do it.

请先登录，再回答此问题。

回答（1 个）

Jon
Jon 2021-1-5
If you want the inital output of your PI controller to be 1800 when the error signal is zero then set the initial value of the integrator to 1800/I where I is the integrator gain
  4 个评论
显示 2更早的评论
Hedi BASBAS
Hedi BASBAS 2023-9-6
Hi Jon,
Could you explain with equations how you choose the inital condition as 1800/K_i ?
Best regards;
Jon
Jon 2023-9-6
For basic PI control the controller output, u is given by u = K_p*e + K_i*E, where e = (y_setpoint - y) and E is the state representing the integrated error. Assume you start your controller with y=y_sestpoint so the error e is zero. Then in order for u = 1800, we have 1800 = K_p*0 + K_i*E. Solving this for E, the initial state of the integrated error, gives E = 1800/K_i

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by