Pressure relief valve with proportional control

Question

Zdenek 2013-4-13

1
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/71895-pressure-relief-valve-with-proportional-control

回答： Mika Herranen 2016-7-1

Hello, I use Pressure relief valve from SimHydraulics library in my model of vehicle and I would need to set valve pressure during simulation. Pressure relief valve model in SimHydraulics library doesn't support it, it is possible to set it only in dialog as constant (I need Pressure relief valve with proportional control). So I realized that three ways are possible. The first is to made my own model with simscape language. So I did but with only partial success, there were some problems with convergence after I added it to my model of hydraulic system. The second way is to use former valve model from library and set its desired pressure via block parameters (function set_param). I added valve and matlab fcn block to my simulink model of vehicle and implemented this function as follows:

function SetBrakeValvePressure(u)
% Nastavuje regulacni tlak bloku Brzdny ventil
% dle hodnoty na vstupu u [bar].
%#codegen
coder.extrinsic('get_param');
coder.extrinsic('set_param');
coder.extrinsic('num2str');
subsystemFullPath = 'MUV74Chvalis_model/HS prevod Chvalis1';
blockName = [subsystemFullPath '/Brake valve'];
% temp = get_param(blockName,'pres_set'); % is OK (only for testing access to Brake valve)
set_param(blockName,'pres_set',u); % gives error !
end

But there is a problem with set_param function. Simulink gives an error: "Error calling MATLAB function set_param". Calling get_param function is without problems. It seems that parameter 'pres_set' can't be set this way......

Finally the third way I should probably use is to make my own model in Simscape language with usage of inharitance. I would inherite my model from Pressure relief valve model in SimHydraulics library and the only thing i would do is to add one input for setting desired valve pressure and set valve pressure in equation section of simscape code. But I don't know how to do it exactly. The first problem is what is the right name of component in SimHydraulics to inherite from it. What I mean (proposal of simscape model implementation):

component PressureReliefValveWithProportionalControl < simhydraulics.?
% Pressure relief valve with proportional control
inputs
    p_set = { 0, 'Pa' }; % Ps:top 
end
equations
    pres_set = p_set;
end 
end

Can anybody help me, please ? Thank you for any help. Zdenek

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Guy Rouleau 2013-4-15

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/71895-pressure-relief-valve-with-proportional-control#answer_82348

I recommend using a Pressure Sensor and the Variable Area Orifice. then write a Simscape component (or use blocks from the Physical Signals section of the Library) to implement the relation you need between the measured pressure and the opening of the orifice.