Antenna toolbox feed point

2021 1 17
1 个回答
更新时间：2022 3 4
4 次查看（30 天）

0 个投票

I'm trying to use the Matlab antenna toolbox, and I have some doubts.
I've used the designer for a dipole antenna. I saw one single feed point, but a dipole must have a centered feed between the two arms, not a single point.
What I've missed about the feed point?
Thanks,
Fabrizio

请先登录，再回答此问题。

回答（1 个）

Chandu
Chandu 2022-3-4

0 个投票

Hi,
Feed point on the Antenna is where the radio frequency electrical power is applied. In Antenna Toolbox, by default the feed point is at the centre of the Dipole Antenna. Strip Dipole Antenna can be created by the following MATLAB command (where the Feed point is at the centre),
d=dipole
If the Feed point needs to be moved between the two arms of the dipole, use the following command,
d=dipole (‘FeedOffset’, Value)
The "Value" represents the offset distance from the centre of the Dipole Antenna. Note that “Value” should lie in the range [0,1].
You can also refer to dipole antenna MathWorks Documentation for further reference.

类别

在 帮助中心 和 File Exchange 中查找有关 Full-Wave Analysis 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by