simple program to run servo motor using matlab-raspberry pi
显示 更早的评论
Hello, i wanted to run servo motor connected to the raspberry pi 3 b+ hardware with the following program
clear;
rsp = raspi('192.168.43.23','pi','raspi');
m1 = servo(rsp,26,'MinPulseDuration', 1e-3, 'MaxPulseDuration', 2e-3)
while 1==1
writePosition(m1,90)
end
but i'm not getting any output, someone to help me. thanks
回答（1 个）
Prasanth Sunkara
2021-2-18
移动：Sabin
2023-1-9
0 个投票
It may be possible that you are giving invalid Pulse Duration values when calling the servo function. Confirm the values from the datasheet. Please double check if the pin number you have chosen,26, is connected tightly to the motor and the servo's VCC and especially the GND is properly connect to the pi's GND.
-Prasanth
类别
在 帮助中心 和 File Exchange 中查找有关 MATLAB 的更多信息
2021-1-30
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
