Simulation 3D Lidar Z-coordinate is wrong

1 次查看（过去 30 天）
Bram Surewaard
Bram Surewaard 2021-2-1
回答： Shubham Rawat 2021-2-5
Hey,
I'm using the Simulation 3D Lidar block from Simulink and I noticed there is a problem with the z-coordinate of the data.
When doing the "Lidar SLAM in 3D Simulation" example the z-coordinate of some of the points are below the surface of the road.
The sensor is located at 1.57 meters above the ground so I would suspect the lowest point being -1.57 however there are plenty of point that are lower than that, with the lowest being around -3.
How is this possible if the ground is flat?
I also tested it in different scenes including the completely flat and empty "Open Surface" scene and in all the cases the z-coordinate seems wrong.
Thanks

请先登录，再回答此问题。

回答（1 个）

Shubham Rawat
Shubham Rawat 2021-2-5
Hi,
I have used an example Lidar SLAM in 3D Simulation and I have found that minimum value of Z axis -1.5938. You may run this code sinppet and check:
minim = zeros(1062,1);
for i=1:1062
% out.ptCloudData.signals.values(:,:,:,i);
ptc = out.ptCloudData.signals.values(:,:,:,i);
minim(i) = min(min(ptc(:,:,3)));
end
min(minim)
Hope this Helps!

类别

在 Help Center 和 File Exchange 中查找有关 Simulink 3D Animation 的更多信息

标签

产品


版本

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by