清空筛选条件
清空筛选条件

Info

此问题已关闭。 请重新打开它进行编辑或回答。

Data Acquisition- program oddly resetting SampleRate

1 次查看（过去 30 天）
Dana
Dana 2013-5-9
关闭： MATLAB Answer Bot 2021-8-20
Hello all!
I am using a DataQ acquisition device in Matlab 32-bit with the Data Acquisition toolbox.
On occasion, when I have my sample rate set to 300, it tells me: "Warning: This hardware could not support the requested value of 300 for SampleRate. SampleRate has been set to 1000"
However, if I set SampleRate to 1000, it sometimes sets it back to 300 with the same error message. It seems to me that either sample rate is supported some times and not others.
Also, if I set the program so that after the error displays and the device has started recording it returns the SampleRate, this is always at whatever I set it to, not what the program claims it changed it to.
Anyone have any idea how I find out what the actual sample rate was or keep it from resetting mine?? I need to know how many samples there are per second for further calculations
Thanks -Dana

此问题已关闭。

回答（1 个）

cr
cr 2013-5-9
Finding out the acquisition rate should be quite straightforward using get(ai,'SampleRate'), where ai is the analoginput object.
  1 个评论
Dana
Dana 2013-5-9
Yes, when I run get(ai, 'SampleRate') it returns the value I set it to, even if an error message has informed me that it was reset- so I am unsure which is true.

此问题已关闭。

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by