Simulink Raspberry Pi - SPI Master Transfer/Read Block Receiving Bits Shifting Problem

2 次查看（过去 30 天）
Ege Gediksiz
Ege Gediksiz 2021-3-19
编辑： Ege Gediksiz 2021-3-19
Hello everyone,
I am using a Raspberry Pi Model 3-B to get some sensor readings from an Arduino slave (follower) using the "Master Transfer" block. (sample time= 0.005 s)
I am trying to read two "int16" integers from the Arduino. So as an input I send 2 dummy int16 type values. (I don't need to use them in the Arduino side so they are irrelevant)
In my slave (follower) code I am writing 4 SPDR (SPI Register) commands in an interrupt routine. (Because an SPDR command writes 1 byte and I need 4 bytes for two "int16" types)
The problem is: Let's say my SPDR commands are writing "a", "b", "c" and "d" (any number between 0 and 256) steadily. So my first "int16" read should be a_b and second would be c_d.
But at every sample the readings shifts! What I mean is: first "int16" reading becomes b_c, second becomes d_a then in the next sample c_d for the first and a_b for the second... and so on.
I can't get a steady reading even without changing anything in the slave side. I make slave send the same values for to test the system and it does not work...
Any ideas what is causing this? I have tried changing MSB/LSB setting, SPI bus speed frequency and other things in target hardware resources. Btw I am using I2C with no problems at all, but I need to switch to SPI to make room for other I2C periphrals for Arduino. When Raspberry is the master in I2C lines, I can't read other I2C devices with Arduino.
Thanks in advance.

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Raspberry Pi Hardware 的更多信息

标签

产品


版本

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by