cannot connect to ZYNQ hardware using MATLAB/simulink

9 次查看（过去 30 天）
Afifa Ishtiaq
Afifa Ishtiaq 2021-3-22
移动：Stefanie Schwarz 2022-9-22
Hi,
I'm trying to run simulink example "Transmit and Receive a Tone Using Xilinx RFSoC Device - Part 2 Deployment". I'm using ZYNQ UlltraScale+ ZCU111 RFSOC. Simulink continuously prompts an issue of unable to connect to IP address 169.254.0.2 although the same is written in SD card. I tried to connect it alot of times by continuous reboots. Out of so many tries it gets connected but again fails at Load design step. I've attached snaps of errors, sd card content (firmware), vivado binaries. I performed the same procedure on the other board and exampe ran succesfully. I have also attached SD card content for board too in folder SD card 1. Does anyone have any idea what can be the possible issue?

请先登录，再回答此问题。

采纳的回答

Urmila Rajpurohith
Urmila Rajpurohith 2021-3-29
移动：Stefanie Schwarz 2022-9-22
Hi
This might be because of the SSH connection which could not be established via Ethernet.
Try the troubleshooting steps mentioned in the below link where you posted your query:
https://www.mathworks.com/matlabcentral/answers/408583
Hope this helps!

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Xilinx FPGA and SoC Devices 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by