Simscape Error ; The following Inductors are connected together

27 次查看（过去 30 天）
Sreeraj A
Sreeraj A 2021-3-24
评论： Issac 2025-10-22，6:56
Hello,
I have a Boost PFC which I am trying to convert to interleaved architecture when tried running the simulation getting the error
Thanks in Advance.
  2 个评论
hamza hamid
hamza hamid 2021-3-24
Please me your Simulation model I will check the problem. This my email:hamidamza@yahoo.fr I have Matlab 2016b
Issac
Issac 2025-10-22，6:56
Interleaving a Boost PFC can be tricky especially with phase timing and current sharing between inductors. Double-check your control signals and ensure both phases have properly matched inductors and gate timings to avoid simulation errors.

请先登录，再进行评论。

请先登录，再回答此问题。

采纳的回答

Joel Van Sickel
Joel Van Sickel 2021-3-24
You can place a large resistor between the two inductors and connect it to ground. Start with 1e6 ohms.
Regards,
Joel
  3 个评论
显示 1更早的评论
Joel Van Sickel
Joel Van Sickel 2021-3-25
yes, that should be fine, but to see how much it is affecting your simulation, you can measure the current going through the resistor. If it is above 1-2% of your system current, you may want to make it larger. (the smaller the resistor, the more innacurate your model will be, but the faster it can simulate. The larger the resistor, the more accurate, but the slower the model might run).
Sreeraj A
Sreeraj A 2021-3-26
Hello Joel,
Thank you very much for the information and support. Much appreciated.
Regards.

请先登录，再进行评论。

更多回答（0 个）

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Foundation and Custom Domains 的更多信息

标签

产品


版本

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by