Simulation does not complete 100% compilation

shalaka sitre

2021 3 27

0 个回答

2 次查看（30 天）

0 个投票

My simulink simulation doesnt compile upto 100% i domnt know why. Tried changing step time , stop time and sampling size.

2 个评论
显示无隐藏无

Pratheek Punchathody 2021-3-30

Can you explain a bit more about the use case or incase of any error that is occuring ? This would help the community to get more understanding on the issue.

shalaka sitre 2021-4-1

Screenshot 2021-03-31 at 9.34.29 PM.png

so i made one simulation of a multidrive system and used the power gui and logged all the scopes.

Then i went ahead and created a single unit system consisting of three phase power source , rectifoer inverter and load. the powergui doesnt seem to record the inputs from the scope. all the scopes are shown from my previous file which i already closed.

i dont knw why.

请先登录，再进行评论。

请先登录，再回答此问题。

Follow Question