Initializing GUI through GUIDE

2013 6 11
3 个回答
回答已采纳
3 次查看（30 天）

0 个投票

I am trying to learn making GUIs in matlab using guide. Upon, opening a GUI layout using guide command, I understand that a new figure shall be created and it should be saved to start with.
However, whenever I attempt a save I get an error as shown in the screenshot in the following link: https://dl.dropboxusercontent.com/u/60477323/error%20message.jpg
Can someone please suggest what is going on.

请先登录，再回答此问题。

 采纳的回答

yeshwanth manhcuri
yeshwanth manhcuri 2013-6-12

0 个投票

try to reinstall guide n luk in help....

1 个评论
显示 -1更早的评论 隐藏 -1更早的评论

Santosh
Santosh 2013-6-12
I went ahead and installed a new version of Matlab (R2013a) and the problem disappears.

请先登录，再进行评论。

更多回答（2 个）

Vishal Rane
Vishal Rane 2013-6-12

0 个投票

Your GUI fig file and the corressponding mfile are probably out of sync. Open a blank gui and try saving it as it is.
Santosh
Santosh 2013-6-12

0 个投票

I have identified the real culprit.
The real culprit was the conflict between the assert.m script built in matlab and assert.m script that was part of a submission I had downloaded from FILEX.
-- Santosh

类别

在 帮助中心 和 File Exchange 中查找有关 Historical Contests 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by