Polyspace justifications added inside the code not available in generated polyspace reports

4 次查看（过去 30 天）
Narayan Narvekar
Narayan Narvekar 2021-4-6
回答： Andreas Apostolatos 2021-5-25
Hello,
I have observed that the polyspace justifications that are added inside the code as a code comment, are not available in the generated polyspace pdf reports.
In the polyspace access server these justifications can be correctly viewed (as shown in the below image). However, the status of the warnings is still "Unreviewed" in the generated polyspace pdf reports.
Could you please provide a solution to this issue?
Best Regards,
Narayan

请先登录，再回答此问题。

采纳的回答

Andreas Apostolatos
Hello everyone,
The cause of the issue was that the code annotation was added one line above the line of code that resulted in the defect and not on the same line of code, which is the expected workflow. See the following MATLAB Answers thread for more information,
https://www.mathworks.com/matlabcentral/answers/839120-why-isn-t-a-justification-appearing-in-the-generated-polyspace-report-although-i-can-view-it-in-the
Kind regards,
Andreas

更多回答（1 个）

Anirban
Anirban 2021-4-8
编辑：Anirban 2021-4-9
Did you generate the report from a result after uploading to Polyspace Access? This workflow seems to report all review information, whether entered through code annotations or through the Access UI.
To generate a report from a result uploaded to Polyspace Access, you have to use the polyspace-report-generator command with -host-name and -run-id. (Note also that prior to generating reports from Polyspace Access on an HTTPS, you have to configure a keystore using the -configure-keystore option.)
  4 个评论
显示 2更早的评论
Narayan Narvekar
Narayan Narvekar 2021-4-12
Hi,
We tried generating the reports directly from the results folder. Now, the code justifications are exported correctly into the pdf reports. But this solution does not work well, because the comments from the Polyspace Access are not covered in the report.
So there seems to be a problem in the Polyspace Access.
Best Regards,
Narayan
Anirban
Anirban 2021-4-12
编辑：Anirban 2021-4-12
Yes, this will not solve the problem. The workflow of uploading to Access and then reporting the results with justifications, is the intended one. I just wanted to see if there is something specific in the nature of the code annotations that was causing them to not be reported.
If the issue is happening for any project uploaded to Polyspace Access, this needs to be investigated in more detail. Please contact MathWorks Technical Support for a deeper analysis of the issue.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Troubleshooting in Polyspace Products for Ada 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by