To find efficiency of inverter with constant dc input voltage and resistive load

11 次查看（过去 30 天）
V Vaishnavi Kumar
V Vaishnavi Kumar 2013-6-22
回答： Joel Van Sickel 2020-12-11
the input dc current to the inverter is pulsating with ripples, so iuse mean block to measure averaged dc i/p current. the average time is 0.02 seconds as the output frequency is 50 Hz.
Im using unipolar sinusoidal pulse width modulation (PWM) for switching, and getting nearly sinusoidal output.
I use rms block with fundamental frequency 50Hz to measure voltage across and current through resistor.
But he measured input power by multiplying dc voltage and averaged input current is different for different simulation times, the same occurs with output power,
What should be the simulation time, and what are the setting tio be done in the model to find correct efficiency

请先登录，再回答此问题。

回答（1 个）

Joel Van Sickel
Joel Van Sickel 2020-12-11
Instead of trying to set up those blocks properly, you can measure instaneous power (V*I) and integrate it over a period of time, then divide by that period of time to get the average power. Do this for the exact same period on the output, and you can compare results. This will not be accurate if the time period is to small (as some energy may stored in the converter) but will work if you make sure to allow a number of cycles to be included in the period. Ideally, the time measurement will also be a multiple of your fundamental frequency. 1 second of simulation would be nice for a 50Hz system, but you could start with 10 cycles to get a pretty good estimate.

社区

更多回答在  Power Electronics Control

类别

在 Help Center 和 File Exchange 中查找有关 Electrical Block Libraries 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by