two phase FEM parametrized motor

5 次查看（过去 30 天）
Federico Manfrin
Federico Manfrin 2021-4-15
编辑： Federico Manfrin 2021-4-26
Is there a way to model a two phase motor using fem-exported flux and torque table?
Thanks

请先登录，再回答此问题。

回答（1 个）

Amrtanshu Raj
Amrtanshu Raj 2021-4-23
Hi,
You can use a FEM-Parameterized Rotary Actuator block to implement the 2 phase motor. You can pass the values for torque and flux as params to the block.
Hope this helps !!
  1 个评论
Federico Manfrin
Federico Manfrin 2021-4-25
编辑：Federico Manfrin 2021-4-26
There is just one phase input in this block, how can I setup this block to have more phase input?
Should be correct to use one block - one motor phase (I think it's not, because in this way the flux iteration should be negletted)?
Is it possible to know how the "FEM parametrized PMSM" works under the mask? (to have at least small pieces of the souces, just to understand how to setup a two-phase simscape custom block version of this component, which is three-phase only).
Thanks

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Permanent Magnet 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by