How to find frequency from image of spectrogram?

7 次查看（过去 30 天）
Sunil Shahi
Sunil Shahi 2013-6-30
Here is what I have done so far.
[W,fs]=wavread(FileName); %this reads a wave file
[~,~,~,P]=spectrogram(W(:,end),tres,tres/2,fres,fs); %tres is time resolution %and fres is frequency resolution.
I=flipud(-log(P)); %here 'I' gives the spectrogram image in a matrix.
imshow(I,[]); %this line will display the image.
now my question is if I choose a pixel co-ordinate from the image matrix I how can I get its frequency?

请先登录，再回答此问题。

回答（1 个）

Wayne King
Wayne King 2013-6-30
编辑：Wayne King 2013-6-30
If you output the vector of frequencies from spectrogram(), you will have the frequency information.
t=0:0.001:2;
x=chirp(t,0,1,150);
[y,f,t,p] = spectrogram(x,256,250,256,1000);
Each row of p corresponds to the frequency at the corresponding element of the vector, f. But keep in mind, that it's only as good as the frequency resolution you have. If you're looking for a technique that gives you instantaneous frequency and time behavior for a signal, it does not exist. You can only obtain information about a time-frequency rectangle of a minimum area.

类别

在 Help Center 和 File Exchange 中查找有关 Time-Frequency Analysis 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by