Simple Matlab & Arduino Serial Communication

18 次查看（过去 30 天）
Tyler
Tyler 2013-7-1
评论： Ana-Maria Moga 2021-7-24
I am attempting a running the following program and am getting strange results. After opening the serial port, the Arduino sends a "Ready" command to matlab. Then it sends a uint16 (2 bytes) value of 500 to the arduino. The arduino simply echoes what was received back to matlab in HEX.
When I run this I expect readData to equal 0x01F4, but I get 0xC0F4. Any suggestions?
Arduino CODE:
byte incomingByte1;
void setup(){
pinMode(2,OUTPUT);
Serial.begin(115200);
Serial.println("Ready");
}
void loop() {
digitalWrite(2,LOW); //turn off LED
delay(500);
if (Serial.available() > 0) {
digitalWrite(2,HIGH); //flash LED everytime data is available
delay(500);
incomingByte1 = Serial.read(); //read incoming data
Serial.println(incomingByte1,HEX); //print data
}
}
Matlab CODE:
clear
clc
s=serial('COM7','BaudRate',115200);
fopen(s);
readData=fscanf(s) %reads "Ready"
writedata=uint16(500); %0x01F4
fwrite(s,writedata,'uint16') %write data
for i=1:2 %read 2 lines of data
readData=fscanf(s)
end
fclose(s);
delete(s);
OUTPUT:
readData =
Ready
readData =
F4
readData =
C0
  3 个评论
显示 1更早的评论
avram alter
avram alter 2019-2-14
It's been nearly 6 years, but from the bottom of my heart, thank you. this thing actually worked to solve my problems.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

islam dib
islam dib 2020-12-8
Hello,
How can I read data sending from arduino via serial port, in Matlab?

类别

在 Help Center 和 File Exchange 中查找有关 MATLAB Support Package for Arduino Hardware 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by