dbstop if error: manually fixing the error and continue?

51 次查看（过去 30 天）
covariant_cat
covariant_cat 2013-7-1
Hi all,
Let's say I toggle on the dbstop if error. And the matlab automatically stops at the error, is it possible for me to manually fix the error and continue the code execution (right from the place where Matlab stops, instead of re-running the code from the beginning)?
Thanks in advance!
Best, Liao

请先登录，再回答此问题。

采纳的回答

Jan
Jan 2013-7-2
The documentation of dbstop is clear in this point:
dbstop if error — Run-time error that occurs outside a try/catch block. You cannot resume execution after an uncaught run-time error.

更多回答（2 个）

Youssef Khmou
Youssef Khmou 2013-7-1
hi,
Yes, if you put the command dbstop if error at the top of the M-file and run your code, when the compiler finds the error, the cursor indicates the line , then your press "F5", fix the error and re run, repeat the process until the code is error-free .
  3 个评论
显示 1更早的评论
Youssef Khmou
Youssef Khmou 2013-7-1
ok
You go to the menu of the M-file page, you click on cell and then enable cell mode , next you divide your code into parts using the notation %% in the beginning and end of each part, then this when a cursor is placed somewhere in specified cell, you click on evaluate cell in top right .
I hope this is clear,
More information can be found in the following page : http://blogs.mathworks.com/community/2009/06/08/using-the-cell-mode-toolbar/

请先登录，再进行评论。

per isakson
per isakson 2013-7-1
编辑：per isakson 2013-7-1
AFAIK: The answer is NO. It is not possible.
However,
  1. you can fix the line, but don't save
  2. select the line, right-click and Evaluate Selected (F9) to ensure that the fix works
  3. select lines before and after the fixed line and Evaluate Selected
But eventually you must save and re-run.

类别

在 Help Center 和 File Exchange 中查找有关 Debugging and Analysis 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by