How to trim the non-manifold triangle off the stl file?

3 次查看(过去 30 天)
Hi everyone
I have a question about the 3D stl file processing.
Suppose that I have the 3D geometry (stl file).
I use stlread and trimesh command to plot it, then I found that some of elements are non-manifold.
I try to directly remove these two triangule faces for about entire afternoon, but I haven't done it succefully yet.
Could any one give me some suggestions?
Attached is the stl file, to view the stl file, with the codes as below:
fv=stlread('test.stl')
figure();
trimesh(fv);
axis equal

回答(1 个)

Bruno Luong
Bruno Luong 2021-4-23
There is SW that can detect topology issue and attempt to correct it, such as

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by