How to trim the non-manifold triangle off the stl file?

3 次查看（过去 30 天）
Daniel Chou
Daniel Chou 2021-4-23
回答： Bruno Luong 2021-4-23
Hi everyone
I have a question about the 3D stl file processing.
Suppose that I have the 3D geometry (stl file).
I use stlread and trimesh command to plot it, then I found that some of elements are non-manifold.
I try to directly remove these two triangule faces for about entire afternoon, but I haven't done it succefully yet.
Could any one give me some suggestions?
Attached is the stl file, to view the stl file, with the codes as below:
fv=stlread('test.stl')
figure();
trimesh(fv);
axis equal

请先登录，再回答此问题。

回答（1 个）

Bruno Luong
Bruno Luong 2021-4-23
There is SW that can detect topology issue and attempt to correct it, such as
https://www.meshlab.net/

类别

在 Help Center 和 File Exchange 中查找有关 STL (STereoLithography) 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by