how to make the small ball slide into the groove in simscape

Question

amatoallah ouchen 2021-4-24

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/812265-how-to-make-the-small-ball-slide-into-the-groove-in-simscape

评论： amatoallah ouchen 2021-4-27

rotating_groove_cylinder_good_trial.slx

Good day All!

I have a problem , I could do almost all the mechanism, my problem is how to make slide the little ball into the groove. whenever i run the program i got the follwing error message

['rotating_groove_cylinder_good_trial']: The following errors were found in the model rotating_groove_cylinder_good_trial.

Caused by:

['rotating_groove_cylinder_good_trial/Solver Configuration']: *** Model not assembled: position violation *** Resolve this issue in order to simulate the model.

the wheel rotates around a fixed hinge.

I have joined the program file,

0 个评论
显示 -2更早的评论隐藏 -2更早的评论

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Juan Sagarduy 2021-4-27

1
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/812265-how-to-make-the-small-ball-slide-into-the-groove-in-simscape#answer_685705

Hello there

I gave the mechanism a good try. It is all about positioning components with precision and then use the spatial force contact block wisely. Hope this can take you further in yoru endeavours. The diagram I refer too which you posted is found as attachment

Good Luck to you / Juan