How can I plug inverse kinematics to a Simscape multibody?

10 次查看（过去 30 天）
Hwajin Choi
Hwajin Choi 2021-4-26
评论： Hwajin Choi 2021-4-26
Hello,
This is my Simulink model of a delta robot using Simscape multibody. I have an inverse kinematics matlab code. How can I plug it into the Simulink model?

请先登录，再回答此问题。

回答（1 个）

Juan Sagarduy
Juan Sagarduy 2021-4-26
Hello there
You need to set the joint in kinematic mode (Actuation >> Motion - Prescribed / Torque - automatically calculated) See below.. Then feed the joints with a time-dependent trace matching the duty cycle you expect the mechanism to execute. See that a little arrow pops up so that the signal can be connected.
Best of Luck / Juan
  1 个评论
Hwajin Choi
Hwajin Choi 2021-4-26
Rather than setting the motion manually, I want to make the robot moves corresponding to the inverse kinematics I coded. The inverse kinematics calculates revolute joint angles with given cartesian position of an end effector x,y, and z.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Multibody Modeling 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by