清空筛选条件
清空筛选条件

Using Polyfit in Simulink

3 次查看（过去 30 天）
Sheetansh Kaushik
Sheetansh Kaushik 2013-7-16
回答： Sebastian Castro 2015-5-25
Hi! Please consider the following:
1. X[501x1]
2. Y[501x1]
I am trying to use the polyfit block simulink. After setting the Order for 8, the last 4 values are always zero. similarly, for order 7, last 3 values are always zero and so on until 5, where i get no zeros. Please advise whether i am using the system in-correctly or my understanding is flawed??
  2 个评论
Sheetansh Kaushik
Sheetansh Kaushik 2013-7-16
编辑：Sheetansh Kaushik 2013-7-16
http://i40.tinypic.com/316krib.jpg
Here is the link for the Model Screenshot.
Kilian
Kilian 2015-5-25
Did you receive an answer or found a solution? Have the same problem.

请先登录，再进行评论。

请先登录，再回答此问题。

回答（1 个）

Sebastian Castro
Sebastian Castro 2015-5-25
Did you try double-clicking the Display block and changing the Format options? The default is "short", which may not show the smaller higher-order values.
- Sebastian

类别

在 Help Center 和 File Exchange 中查找有关 Simulink Functions 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by