stepper motor control using a usb to parallel adapter

2021 5 8

0 个回答

更新时间：2022 5 1

17 次查看（30 天）

请先登录，再回答此问题。

请先登录再关注

请先登录，再回答此问题。

请先登录再关注

显示更早的评论

0 个投票

Hi,

I have a stepper motor which uses a parallel port. My computer does not have any parallel port. So I used a usb to parallel adapter and connected it to a usb port of my computer. How can I send signal to the usb to control it? I have a MATLAB version R2019b, 64-bit

I have a code which uses digitalio, but it does not work for the adapter or usb port.

Thanks!

2 个评论
显示无隐藏无

Michele Midrio 2022-3-3

Hi,

i have the same problem and found no easy solution for it. Did you manage to solve the problem?

Thank you in advance

Michele

Ho Ha 2022-5-1

Hi Michele,

I used an Arduino Ono microcontroller to send the signals.

And I had to use it in MATLAB. So I programmed it in Arduino IED and then convert it to .hex and used it in matlab.

Hope this helps.

H.

请先登录，再进行评论。

请先登录，再回答此问题。

请先登录再关注

回答（0 个）

请先登录，再回答此问题。

类别

在帮助中心和 File Exchange 中查找有关 Simulink Supported Hardware 的更多信息

产品

MATLAB

版本

R2019b

标签

2021-5-8

2022-5-1

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Translated by