Problem using simscape model provided in Matlab File exchange
显示 更早的评论
I am using R2009a. I downloaded the model file in the followling link.
While building the simscape model using the scc_build it shows some error. The error is the following.
*Error: No compiler options file could be found to compile source code. Please run "mex -setup" to rectify. *
when I run mex -setup command it again shows the following commands
*_>> mex -setup Please choose your compiler for building external interface (MEX) files:
Would you like mex to locate installed compilers [y]/n? y
Select a compiler:
[0] None
Compiler: _*
Please suggest what might be the problem
采纳的回答
Shashank Prasanna
2013-7-19
1 个投票
Hi Arvind, Check the support compilers and install them:
If you still see an issue feel free to contact the author of the submission
3 个评论
Shashank Prasanna
2013-7-19
mex -setup will tell you what compilers you have installed. Looks like you don't have any. Please use the link above to get the free supported compiler.
Shashank Prasanna
2013-7-19
Again if you have more file specific questions the author of the file will be the best person to help you. I already provided the link above.
Aravind Kumar
2013-7-21
更多回答（1 个）
Aravind Kumar
2013-7-19
0 个投票
1 个评论
Shashank Prasanna
2013-7-19
Please see my answer in the comment above. This will make it easier to track an answer if someone else is looking for an answer to the same question.
类别
在 帮助中心 和 File Exchange 中查找有关 Introduction to Installation and Licensing 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
