Voltage Measurement block error
显示 更早的评论
How to remove this error: Input two of Voltage Measurement block Three-Phase V-I Measurement' is not properly connected to the network.
5 个评论
Bruce Davis
2014-7-16
If your Voltage Measurement Block is connected correctly, check your reference. If the reference input to the block is ground and there is no ground in your system, this will cause problems.
kamlendra rathore
2016-5-3
please change your configuration of 3 phase load to Y ground or to say the load 3 phase which you are using must have ground connection.
Mahdi Zolfaghari
2017-3-16
MD SAIF MALIK
2019-11-30
can you please ellaborate sir, how you remove this error
Uttam Reddy Pailla
2021-6-18
Please let me know. Even i am facing the same issue
采纳的回答
dpb
2013-7-24
0 个投票
Make the proper connection...
No can help w/o any other info--the message says the 2nd of the three inputs isn't actually connected to anything so the problem is upstream from there.
更多回答（5 个）
ARPAN MALKHANDI
2018-1-10
1 个投票
Provide proper grounding of the source and the loads
lal mohammed
2015-4-28
0 个投票
i have a same problem with upfc ..can any 1 help me with this project!!
srinath r
2016-3-30
Voltage Measurement
if true
% code
end
Nida Riaz
2017-3-16
0 个投票
Hello; What is the main difference between UPFC (Phasor Model) and UPFC (Detailed Model)? Please Guide Me. Thank You
类别
在 帮助中心 和 File Exchange 中查找有关 Converters (High Power) 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
