guide GUI button pressed to run an external Arduino program
显示 更早的评论
Hello,
I am not sure if this is possible but is there anyway that when i press a button in a matlab guide GUI that then i can run external arduino code in the arduino ide?
Or is there a way to write code in MATLAB that can reset my arduino? I want to reset the arduino without having to press the physical reset button on the arduino board
Thank you
I am using matlab version R2019b
i am using arduino version 1.8.15
i am using an arduino nano
采纳的回答
Shubham Khatri
2021-6-1
Hello,
You can reset arduino using a MATLAB code. I am attaching a code snip to do the same. To do this, you need to connect any one pin to the reset pin and add this code to your code.
writeDigitalPin(a, '4', 1); %After connecting pin 4 to reset pin
pause(0.5);
writeDigitalPin(a, '4', 0); %Pulling pin from High to low
pause(0.5);
Apart from this, you can also use the builtin Aurdino function
resetFunc
to reset the Aurdino. You need to define the function and then call it to reset your Aurdino
Hope it helps
更多回答（0 个）
类别
在 帮助中心 和 File Exchange 中查找有关 Arduino Hardware 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!
Translated by 
