How can I simulate the movement of a node?

1 次查看（过去 30 天）
Li Qing
Li Qing 2021-5-28
编辑： Li Qing 2021-5-28
The mobile sensor node sends a message every 10m. How can I use MATLAB to simulate the mobility of the node?
  2 个评论
Sulaymon Eshkabilov
Sulaymon Eshkabilov 2021-5-28
Miriad of simulations can be done in MATLAB and Simulink. But how to start this issue depends on the mathematical formulation or numeircal set up principles of your sensor data. If you can post some data or formulation, then some specific advice can be provided.
Li Qing
Li Qing 2021-5-28
编辑：Li Qing 2021-5-28
Hi,the network scenario is shown in the figure below:
The blue mobile beacon moves in the vertical direction.In general, if the node is stationary, its position can be represented by (x, y, z).But the mobile beacon is not stationary, so its coordinates (x, y, z) are constantly changing.My current solution is to store all possible positions of the mobile beacon in the matrix before doing other simulations.Then determine which coordinates need to be used.
%store coordinates every 10m
%Water depth 3000m
depth_interval = -transpose(10:10:3000);
%(x1,y1) = (0,355)
%(x2,y2) = (2500,335)
%...
anchor1 = [repmat([0,355],300,1),depth_interval];
anchor2 = [repmat([2500,335],300,1),depth_interval];
...
Is there a better way to simulate the movement of nodes?

请先登录，再进行评论。

请先登录，再回答此问题。

回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Simulation 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by