simscape electronics simulation extremely slow

20 次查看（过去 30 天）
Kunji
Kunji 2013-8-14
评论： Richard about 18 hours 前
Hello MATLAB community, newbie here. I am trying to simulate a rectifier on Simscape but the simulation is extremely slow. You can check out the screenshot at http://i1302.photobucket.com/albums/ag127/renguoma/rectifier_simscape_zps57f15786.jpg
I have tried using ode23t solver with accelerator and while it did run faster, the output seems incorrect, as can be seen from the link below. http://i1302.photobucket.com/albums/ag127/renguoma/946efd9d-1bb2-4056-acc2-eedb8d7a9475_zps959bcf1e.jpg I expect the output to be DC and yet I see a sine wave. I have simulated the same circuit in SimPower and had no problems with it. Please help.

请先登录，再回答此问题。

回答（1 个）

Joel Van Sickel
Joel Van Sickel 2021-5-21
This is an effort to answer old unanswered questions on Matlab answers:
The signal is rectified, it's just that the capacitor is not charging and holding it's charge. It is likely the circuit parameters need to be changed such as a larger resistor. This could also explain the slow simulation time as the smaller the rc time constant, the slower the simulation will be.
  1 个评论
Richard
Richard about 3 hours 前
Doesn't explain the discrepancy with simulation in SimPowerSystems which the the User mentions as being much faster.

请先登录，再进行评论。

类别

在 Help Center 和 File Exchange 中查找有关 Simscape Electrical 的更多信息

标签

产品

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by