How to not hardcode Simulation time

2 次查看（过去 30 天）
Shreneek Upadhye
Shreneek Upadhye 2021-6-14
回答： Sanchit Trivedi 2021-6-14
MASS = input('Enter mass value = ');
FrictionCoefficient = input('Enter Friction coefficient value = ');
EngineForce = input('Enter Engine Force value = ');
Fwind = input('Enter Fwind value = ');
out= sim('control.slx',0:0.01:120);
figure
hold on
plot(out.tout,out.velocity,'linewidth',2);
grid on
xlabel('time in s')
ylabel('velocity in m/s')
this is my code how can i make is softcode like mass,FrictionCofficent ,I want to make the Simulation time (,0:0.01:120) in soft code like above so that i can put the value in command windows

请先登录，再回答此问题。

回答（1 个）

Sanchit Trivedi
Sanchit Trivedi 2021-6-14
The following code should allow you to softcode the simulation time and input values from the Command Window.
SimEnd = input('Enter Simulation End Time = ');
SimStep = input('Enter Interval = ');
SimTime = 0 : SimStep : SimEnd
out = sim('control.slx',SimTime);

类别

在 Help Center 和 File Exchange 中查找有关 MATLAB 的更多信息

标签

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by