Simulink coder with PID - Algebraic loop when using antiwindup
2 次查看(过去 30 天)
显示 更早的评论
I'm using simulink coder to generates code for the STM32 microcontroller. My model uses a couple of PIDs and everything works fine so far. However, i noticed that i need to have some sort of anti windup active in the PIDs. I tried to use both the back-calculation and clamping options, but in either case i get the following error:
Algebraic loops are not supported in generated code. Use the 'ashow' command in the Simulink Debugger to see the algebraic loops
I'm surprised that there is any algebraic loop in the first place since the anti windup error feedback goes through an integrator (for back-calculation).
Is there any way to work around this?
Thanks, Alex
0 个评论
回答(1 个)
Arkadiy Turevskiy
2013-8-30
In the block dialog, make sure you have "Forward Euler" selected for both integrator method and filter method.
HTH.
0 个评论
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Discontinuities 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!