Variant subsystem throws error because it does not recognize parameter in mask

Question

Zeno Pavanello 2021-7-6

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/872738-variant-subsystem-throws-error-because-it-does-not-recognize-parameter-in-mask

编辑： Stefanie Schwarz 2024-2-12

When I try to run a model in which a variant subsystem is present I get the following error:

Variant control 'maxdeg == 1' used by block 'model/Mechanical model/Chaser/Chaser Bus/Tanks/Sloshing Tank 1/Gravity EGM2008 ECI/Gravity EGM2008/Variant gravity model' should return a logical value.

The variable maxdeg is defined in the mask of the subsystem "Sloshing Tank 1" and is given as a parameter to the block "Gravity EGM2008 ECI", which is defined inside a custom library. Sometimes this error is accompanied by another error which states that the workspace of the masked subsystem is not initialized. I cannot debug the problem because when I try to run a simpler model with the single block "Sloshing Tank 1" or with the block "Gravity EGM2008 ECI" it runs smoothly.

If it may help, the model includes a Simscape Multibody system.

Thank you in advance for your help.

2 个评论
显示无隐藏无

耀仁邢 2023-2-7

I have the same problem as you. The most interesting thing is that I can implement this function on matlab2021b, that is, use the variables defined in the mask to switch the variant subsystems, but there is the same error message as you on 2019b

geieraffe 2023-6-21

Any solution here?

Because I have the same problem. Workaround for me is using label control and promoting it to the higher mask.

But I want to set a variable so I can change my controled subsystems all over the model.

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Steve Miller 2021-9-29

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/872738-variant-subsystem-throws-error-because-it-does-not-recognize-parameter-in-mask#answer_797459

编辑：Stefanie Schwarz 2024-2-12

Hi Zeno - take a look at this documentation page:

https://www.mathworks.com/help/releases/R2021b/simulink/ug/switching-between-variants.html

Make sure you have defined your variant control as shown on this page. I usually find it helpful to open the Variant Manager to check that it is set up properly.

--Steve