Embedded System
3 次查看(过去 30 天)
显示 更早的评论
How can we use Simulink to design our embedded system.. Can we interface MATLAB and Simulink with our Micro-controller and control its operation.. Is it possible... and How???
I am using PIC16F877A micro-controller...
0 个评论
采纳的回答
Walter Roberson
2011-6-5
Also perhaps this MATLAB File Exchange Contribution: http://www.mathworks.com/matlabcentral/linkexchange/links/1303-embedded-target-for-dspic-a-matlab-toolbox-for-real-time-control-of-dspic-microcontrollers
(Note: I do not myself know if there is a difference between the dsPIC33 and the PIC16*)
4 个评论
Walter Roberson
2011-6-5
http://www.mathworks.com/matlabcentral/fileexchange/15955-read-lm73-temperature-sensor shows reading a temperature sensor using your chip.
And see these old practical notes:
http://www.mathworks.com/matlabcentral/newsreader/view_thread/45329
http://www.mathworks.com/matlabcentral/newsreader/view_thread/264868
Walter Roberson
2011-6-5
I'm think I might be missing something. The PIC16F877A only has 368 bytes of RAM. That would be very limited to use as a USB controller such as you mentioned in your previous post. Are you sure your USB controller is not communicating via serial emulation to the UART that is on-board the PIC16F877A ?
更多回答(0 个)
另请参阅
类别
在 Help Center 和 File Exchange 中查找有关 Startup and Shutdown 的更多信息
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!