Unable to run simulation for a PV microgrid

Question

Ajibola Adeleke 2021-7-27

0
链接

此问题的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/886889-unable-to-run-simulation-for-a-pv-microgrid

移动：DGM 2022-12-25

I keep getting the error below when running my simulation for a PV microgrid:

An error occurred while running the simulation and the simulation was terminated

Caused by:

Derivative of state '1' in block 'untitled_real/PV Array/Diode Rsh/Transfer Fcn' at time 0.01 is not finite. The simulation will be stopped. There may be a singularity in the solution. If not, try reducing the step size (either by reducing the fixed step size or by tightening the error tolerances)

2 个评论
显示无隐藏无

Kamran Awan 2022-7-5

移动：DGM 2022-12-25

Hi @Ajibola Adeleke

were you able to solve this issue?

Pratyush Das 2022-12-25

How was it solved?

请先登录，再进行评论。

请先登录，再回答此问题。

Answer 1

Kiran Felix Robert 2021-9-24

0
链接

此回答的直接链接

https://ww2.mathworks.cn/matlabcentral/answers/886889-unable-to-run-simulation-for-a-pv-microgrid#answer_794084

编辑：Kiran Felix Robert 2021-9-24

在 MATLAB Online 中打开

Hi Ajibola,

This message may be caused by a singularity in your system. One situation where this may occur is if the values of your states differ by a large magnitude. If this is the case, the Simulink solver will have a hard time resolving your step size within the error tolerance as it attempts to "bounce" back and forth between the states.

To check if this is the case:

1. Return the states of your system as follows:

a) In the model editor go to Simulation-> Configuration Parameters

b) Select Data Import/Export, in the 'Save to Workspace' field, check 'States' to log the states as output

2. Run the simulation.

3. Plot:

plot(tout,xout)

You can see if one of the states is changing over a wide range compared to the others.

There are a couple of things you can do to try to correct this situation.

If possible, you may want to rescale the model so that the states are within a couple of orders of magnitude of one another.

Also, you can set specific error tolerances for the integrator blocks (if any) in your system.

For more information, please refer to 'Specifying the Absolute Tolerance for the Block's Outputs' section in the Integrator block documentation by entering

doc integrator

at the MATLAB command prompt.

To Resolve these, you may also try the following:

Use a stiff solver (e.g. ode15s)

Decrease initial step size, maximum step size, and relative tolerance