How to dynamically change the Mask dialog box in Simulink

5 次查看（过去 30 天）
Sylvain
Sylvain 2021-7-30
评论： Sylvain 2021-8-4
I have created a dynamic mask, which change if the block parameter "Command" is equal to Reset. The Command is set when I click apply, then it hides the Channel and Channel Electrical Parameters inputs, see below
I would like to improve my mask and make it more dynamic, without the need to click on Apply.
I put the piece of code that is in my Mask Editor belwo. Can anyone advise on how to get access directly to the selected Command?
disp('AD5665r')
mask = Simulink.Mask.get(gcb);
switch get_param(gcb,'Command') % I suppose this is where I need to change the code
case {'Write_To_Input_Register_n' ,'Write_To_Input_Register_n_And_Update_all' ,'Write_To_And_Update_DAC_Channel_n'}
[control,handle]=mask.getDialogControl("ChannelA_param_container");
control.Visible='on';
mask.getParameter("Channel").Visible = 'on';
port_label('input', 1, 'VoltageSetpoint')
case 'Reset'
[control,handle]=mask.getDialogControl("ChannelA_param_container");
control.Visible='off';
mask.getParameter("Channel").Visible = 'off';
port_label('input', 1, 'ResetTrigger')
end
port_label('output', 1, 'i2c status')

请先登录，再回答此问题。

采纳的回答

Mark McBroom
Mark McBroom 2021-8-1
I am assuming the code you provided is from the "Initialization" tab? You could try putting the same code in the "callback" for the Command parameter on the Mask Editor -> Parameter and Dialog pane.
  1 个评论
Sylvain
Sylvain 2021-8-4
No, it is from the Icon and Ports. the initialization tab contains the following code, which modify blocks under the mask. Though using the same piece of code (minus the function port_label() ) works very well.
Many thanks
Sylvain

请先登录，再进行评论。

更多回答（0 个）

类别

在 Help Center 和 File Exchange 中查找有关 Author Block Masks 的更多信息

标签

产品


版本

R2021a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by